BSI Grip-It Grip Glue 1 oz

Works Best On:

• Water Craft
• Motorcycles
• Bicycles
• ATVs
• Snowmobiles

• Rubber Mats
• Fiberglass
• Metal
• Hardwoods
• Plastics

Clean the bar area with rubbing alcohol. Unscrew top from nozzle. For finer applications, use the extender tip. Before applying any glue to the grip, have a disposable rag or paper towel within reach to be able to quickly wipe away any excess glue during application. Also place a piece of cardboard or paper plate below the working area to catch any excess glue drip. Apply 4 small beads of Grip-It™ to outer 2" of the handle bar, then apply a generous amount of Grip-It™ to the inside flange of the grip. Align the grip before sliding on, then slide the grip quickly into place. You may need to slightly twist and turn the grip as you slide it into position. Once in position wipe away any excess glue. Glue will set in 10-25 seconds. NOTE: On twist throttles replace sleeve if damaged. Cover any vent holes in sleeve to prevent bonding with handlebar.

1. Cover directly below work area with a cloth to prevent any drips from getting on vehicle (do not use paper).

2. Grip-it™ acts as a lubricant, the more you use the easier the grip will slide on. There will be excess glue that you’ll need to wipe immediately with a cloth towel.

3. It is easier to apply grips if you “spin” it as you’re putting it on. Stop turning when you have the grip in the proper position.

4. Determine mat alignment before applying Grip-it™. Apply the furthest away from you first, and then work your way toward yourself pressing down firmly.

5. Always work in a well-ventilated area.